Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Remove the screws that secure the base cover to the system.
Using a plastic scribe, pry the basecover from bottom left to loosen.
Slide and lift the base cover off the system.
Speakers
Identify the speakers highlighted in blue.
Disconnect the speaker cable from the connector.
Unroute and remove the speaker cable from the routing guides on the system.
Lift the speakers, along with the speaker cable, to remove. Lift from under the rubber grommets.
Install
Speakers
Identify the speaker location highlighted in blue.
Install the speakers in the slots on the system, using the alignment posts as a guide.
Route the speaker cable through the routing guides on the system.
Connect the speaker cable to the system board.
Base Cover
Identify the base cover location highlighted in blue
Slide and align the base cover and press the edges of the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.
Install the screws that secure the base cover.