Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Pry the base cover near the hinges. Pry from recess points near the hinges.
Loosen the base covery by working on the left, right and, bottom sides to open the base cover.
Lift to remove the base cover.
Battery Cable
Identify the battery cable highlighted in blue.
Using the pull tab, disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Wireless Module (WWAN)
Display Assembly
Identify the display assembly highlighted in blue.
Remove the screws that secure the display hinges to the palm rest assembly.
Open the display hinges at an angle.
Gently slide the palm rest and keyboard assembly off the display assembly carefully.
Install
Display Assembly
Position the system to enable the display to be installed.
Identify the display assembly location highlighted in blue.
Align and install the palm rest assembly on the display assembly.
Close the display hinges and align the screw holes.
Install the screws that secure both hinges to the system.
Wireless Module (WWAN)
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover tabs to the slots, press the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.