Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air shroud
Identify the air shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Power Supply Units
Select the power supply unit (PSU) you want to replace
Disconnect the power cable from the power source and from the PSU you intend to remove, and then remove the cable from the strap on the PSU handle.
Press the release latch and slide the PSU out of the system by using the PSU handle.
PIB
Install
PIB
Power Supply Units
Confirm the power supply unit (PSU) you want to replace
Slide the PSU into the system until the PSU is fully seated and the release latch snaps into place.
Connect the power cable to the PSU, and plug the cable into a power outlet.
Air shroud
Identify the cooling shroud location highlighted in blue
Align the slot on the air shroud with the standoff on the chassis.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.