Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Airshroud
Riser 01
Identify the Riser 01 highlighted in blue
Loosen the captive screws on the riser.
Press the blue button on the riser, and holding the touch points lift the expansion card riser 01 from the riser connector on the system board.
Position the part to access the expansion card.
Pull the black card holder before removing the card from the riser.
Pull and lift the expansion card retention latch lock to open.
Pull the expansion card from the riser assembly and the remaining part is riser.
Install
Riser 01
Identify the Riser 01 location highlighted in blue
Position the part to access the port of expansion card.
Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
Close the expansion card retention latch.
Push the black card holder to hold the card in the riser.
Holding the edges or the touch points, align the holes on the expansion card riser 01 with the guides on the system board.
Lower the expansion card riser 01 into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
Tighten the captive screws on the riser.
Airshroud
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.