Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the screws that secure the base cover to the palm rest assembly.
Remove the screws that secure the base cover to the palm rest assembly.
Pry the base cover near the hinges. Pry from recess points near the hinges.
Loosen the base covery by working on the left, right and, top sides to open the base cover.
Lift and remove the base cover off the palm rest assembly.
Memory Module
Identify the memory module highlighted in blue.
Lift the Mylar to access the memory module.
Using your fingertips, carefully spread apart the securing clips on each end of the memory module slot until the memory module pops up.
Slide and remove the memory module from the memory module slot on the system board.
Install
Memory Module
Identify the memory module location highlighted in blue.
Lift the Mylar to access the memory module slot.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Base Cover
Identify the base cover location highlighted in blue.
Place the base cover on the system and snap into place.
Tighten the screws that secure the base cover to the system.
Install the screws that secure the base cover to the system.