Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch until the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Front Bezel
Identify the front bezel highlighted in blue.
Unlock the front bezel by using the key.
Press the release button and disengage the left end of the bezel.
Unhook the right end, and remove the front bezel.
Drive carrier
Select the drive carrier you want to replace.
Press the release button to open the release handle.
Holding the handle, slide the drive carrier out of the drive slot.
Air shroud
Identify the air shroud highlighted in blue.
Holding the edges of the air shroud, lift the air shroud out of the system.
Drive backplane cover
Identify the drive backplane cover highlighted in blue.
Slide the drive backplane cover to the rear of the system.
Lift the drive backplane cover from the system.
Cooling fan cage assembly
Identify the cooling fan cage assembly highlighted in blue.
Rotate the blue release levers to unlock the cage assembly from the system.
Hold the release levers, and lift the cooling fan cage assembly away from the system.
PERC module
Drive Backplane
Identify the hard drive backplane highlighted in blue.
Disconnect the drive backplane cables from the connector on the backplane.
Pull the release tab to disengage the drive backplane from the hooks on the system.
Lift and pull the drive backplane out of the system.
Install
Drive Backplane
Identify the hard drive backplane location highlighted in blue.
Align and insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
Connect the all data, signal, and power cable(s) to the backplane.
PERC module
Cooling fan cage assembly
Identify the cooling fan cage assembly location highlighted in blue.
Align and place the cooling fan cage assembly into the system until seated firmly.
Rotate the blue release levers to lock the cooling fan cage assembly into the system.
Drive backplane cover
Identify the drive backplane cover location highlighted in blue.
Align and place the drive backplane cover on the system.
Slide the drive backplane cover to the front of the system until it fits into place.
Air shroud
Identify the air shroud location highlighted in blue.
Tilt at an angle and align the tabs with the slots on the system and place the air shroud until it is firmly seated.
Drive carrier
Confirm the drive carrier you want to replace.
Press the release button on the front of the drive carrier to open the release handle.
Insert the drive carrier into the slot and slide until it connects with the backplane.
Close the drive carrier release handle to lock the drive in place.
Front Bezel
Identify the front bezel location highlighted in blue.
Align and insert the tabs on the bezel into the slots on the system.
Press the bezel until the release button clicks in place.
Lock the front bezel by using the key.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a flat head or Phillips screwdriver, rotate the lock clockwise to the lock position.