Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Remove the screws that secure the base cover to the system.
Using a plastic scribe, pry the basecover from bottom left to loosen.
Slide and lift the base cover off the system.
Battery Cable
Identify the battery cable highlighted in blue.
Using the pull tab, disconnect the battery cable from the system board.
Press and hold the power button for 20 seconds to ground the system and remove residual static electricity.
Rear I/O Cover
Identify the rear I/O cover highlighted in blue.
Remove the screws on the back of the system that secure the rear cover.
Remove the screws that secure the left and right tron light cables to the system board.
Disconnect the rear I/O cables from the system board.
Push the rear cover away from the system and lift it off the system.
Micro SD-card reader
Install
Micro SD-card reader
Rear I/O Cover
Identify the rear I/O cover location highlighted in blue.
Slide the rear cover towards the system till it snaps into place. Be cautious of the plastic clips under the cover to make sure they are aligned.
Connect the rear I/O cables to the system board.
Install the screws that secure the left and right tron light cables to the system board.
Install the screws that secure the rear cover on the back of the system.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Slide and align the base cover and press the edges of the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.
Install the screws that secure the base cover.