Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Using a plastic scribe, pry the base cover from the top-right corner
Lift the base cover away from the computer.
Battery Cable
Identify the battery cable highlighted in blue.
Use the pull tab to disconnect the battery cable from the connector on the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Memory Modules
Identify the memory module highlighted in blue.
Using your fingertips, carefully spread apart the securing clips until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board.
Install
Memory Modules
Identify the memory module location highlighted in blue.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align and place the base cover on the computer, press the edges and sides of the base cover until it snaps into place.
Tighten the screws to secure the base cover to the computer.