- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Technical overview
- Removing the right-side cover
- Replacing the right-side cover
- Removing the front bezel
- Replacing the front bezel
- Removing the optical drive
- Replacing the optical drive
- Removing the top cover
- Replacing the top cover
- Removing the bottom cover
- Replacing the bottom cover
- Removing the primary hard-drive
- Replacing the primary hard-drive
- Removing the secondary hard-drive
- Replacing the secondary hard-drive
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the power-supply unit
- Replacing the power-supply unit
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the graphics card
- Replacing the graphics card
- Removing the full-length graphics cards
- Replacing the full-length graphics cards
- Removing the memory modules
- Replacing the memory modules
- Removing the power-button module
- Replacing the power-button module
- Removing the top I/O-panel
- Replacing the top I/O-panel
- Removing blower and heat-sink assembly
- Replacing blower and heat-sink assembly
- Removing the VR heat sink
- Replacing the VR heat sink
- Removing the processor fan and heat-sink assembly
- Replacing the processor fan and heat-sink assembly
- Removing the chassis fan
- Replacing the chassis fan
- Removing the processor
- Replacing the processor
- Removing the wireless card
- Replacing the wireless card
- Removing the antenna
- Replacing the antenna
- Removing the system board
- Replacing the system board
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Καλώς ορίσατε
Ιστότοποι της Dell
Ιστότοποι της Dell
Καλώς ορίσατε στην Dell
Ο λογαριασμός μου
- Υποβάλετε παραγγελίες γρήγορα και εύκολα
- Δείτε τις παραγγελίες και παρακολουθήστε την κατάσταση αποστολής
- Δημιουργήστε μια λίστα με τα προϊόντα σας για να έχετε πρόσβαση σε αυτή
- Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
XPS 8910 Service Manual
Procedure
CAUTION: If either
the processor or the heat-sink assembly is replaced, use the thermal
grease provided in the kit to make sure that thermal conductivity
is achieved.
NOTE: The original thermal grease can be reused if the original processor
and heat-sink assembly are reinstalled together.
- Place the processor fan and heat-sink assembly over the processor.
- Align the captive screws on the processor fan heat-sink assembly with the screw holes on the system board.
- In a non-adjacent sequence, tighten the captive screws that secure the processor fan and heat-sink assembly to the system board.
- Connect the processor-fan cable to the system
board.
For more information, see “System-board components”.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\