Update Storage Center Software Using Storage Manager
Update Storage Center software with either the Storage Manager connected
directly to a Storage Center, or
through a Data Collector
Prerequisites
Storage Center must be version 6.7 or later to perform this update. (See Update Version 6.6 Software to update version 6.6 software.)
SupportAssist must be enabled
or the Storage Center Update Utility
must be configured.
About this task
The options
displayed in the Storage Center software
update dialog boxes depend on the type of update performed on the Storage Center.
Steps
If the Storage Manager is connected to a Data Collector, select a Storage Center from the Storage view.
In the right pane, select Actions > System > Check for Update.
The Update Storage Center dialog
box opens and the Storage Center checks for an update.
(Optional) Click Release Notes for information about the update.
Select an Installation Type:
To apply only non-service affecting updates,
select Apply non-service affecting updates.
To apply non-service affecting updates to required
components, select Apply required components — Non-Service
Affecting.
To apply all updates including those affecting
service, select Apply all updates — Service Affecting.
NOTE:Service-affecting installation types require a controller outage. Service
will be interrupted.
Click OK.
(Optional) If the update is service-affecting, the Install Update Confirmation dialog opens. Type the Storage Center Administrator username and password to continue.
Click OK.
The Update Storage Center dialog opens. This dialog displays details of the installation process
and updates those details every 30 seconds. This is also displayed
as a blue message bar in the Summary tab, and in the update status
column of the Storage Center details.
In case of an update failure, click Retry to
restart the interrupted process. If the update is service affecting,
the connection between Storage Manager and Storage Center will
be lost.
If necessary, change the operation mode to Normal after the update is complete.
In the Storage CenterStorage view, click Edit Settings.
The Storage Center Settings dialog box opens.
Click the General tab.
In the Operation Mode field, select Normal.
Click OK.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\