Update Storage Center software with Unisphere Central for SC Series connected either directly to
a Storage Center or through a Data Collector.
Prerequisites
Storage Center must be version 6.7 or later to perform this update. (See Update Version 6.6 Software to update version 6.6 software.)
SupportAssist must be enabled
or the Storage Center Update Utility
is configured.
About this task
The options
displayed in the Storage Center software
update dialog boxes depend on the type of update performed on the Storage Center.
Steps
If you are connected to a
Data Collector, select a
Storage Center from the drop-down list in the left navigation pane of
Unisphere Central.
Click
Summary.
The
Summary view is displayed.
Click (More Actions) and select Check for Update.
The Update Storage Center wizard
opens and the Storage Center checks
for an update.
Select an Update Action:
Select Download Update and
click Download Update to download the update.
Select Download and Install Now to download and apply the update immediately.
(Optional) Click Release Notes for information about the update.
Select an Installation Type:
To apply only non-service affecting updates,
select Apply non-service affecting updates.
To apply non-service affecting updates to required
components, select Apply required components — Non-Service
Affecting.
To apply all updates including those affecting
service, select Apply all updates — Service Affecting.
NOTE:Service-affecting installation types require a controller outage. Service
will be interrupted.
Click Install Update.
Click OK.
(Optional) If the update is service-affecting, the Install Update Confirmation dialog opens. Type the Storage Center Administrator username and password to continue.
Click OK.
If the update is service affecting, the connection
between Unisphere and Storage Center will be lost.
If necessary, change the operation mode to Normal after the update is complete.
In the Storage Center view, click (Settings).
The Storage Center Settings dialog box opens.
In the Storage Center Setting dialog box, click the General tab.
In the Operation Mode field, select Normal.
Click OK.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\