Dell FluidFS Version 6.0 FS8600 Appliance Deployment Guide

Use the Configure IP Addresses for NAS Controller iSCSI HBAs page to configure IP addresses for each iSCSI HBA.

About this task

Use this page of the Add FluidFS Cluster wizard to configure iSCSI HBA IP addresses.

Figure 1. Add FluidFS Cluster Wizard — Configure IP Addresses for NAS Controller iSCSI HBA Page

1. Configure iSCSI HBA IP addresses for the first iSCSI subnet (Storage Center fault domain).
   1. Next to iSCSI Targets, locate the Storage Center iSCSI target IP addresses.
   2. Based on these IP addresses, identify the iSCSI subnet (Storage Center fault domain).
   3. In the VLAN Tag field, type the VLAN ID for the subnet (fault domain).
   4. From the Interface drop-down menu, select the controller interface that is connected to the iSCSI subnet.
      • eth30 / SAN is the upper right port in each controller.
      • eth31 / SAN b is the lower right port in each controller.
   5. Define an IP address for each controller by selecting the controller, clicking Edit Settings, and typing an IP address in the dialog box.
   6. Click Next. The wizard displays connected Storage Center iSCSI target IP addresses for the second iSCSI subnet and automatically selects the unconfigured interface from the Interface drop-down menu.
2. Configure iSCSI HBA IP addresses for the second iSCSI subnet (Storage Center fault domain).
   1. Next to iSCSI Targets, locate the Storage Center iSCSI target IP addresses.
   2. Based on these IP addresses, identify the iSCSI subnet (Storage Center fault domain).
   3. In the VLAN Tag field, type the VLAN ID for the subnet (fault domain).
   4. Define an IP address for each controller by selecting the controller, click Edit Settings, and type an IP address in the dialog box.
   5. Click Next. The iSCSI ports are configured and the Connectivity Report page opens.