Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell FluidFS Version 6.0 FS8600 Appliance Deployment Guide

PDF

Prerequisites

Before configuring the FluidFS cluster with Dell Storage Manager, ensure that you have met the following requirements.

■ Prerequisite
□ Dell Storage Manager and Storage Center are deployed and configured. See SAN Configuration.
□ You have the required network credentials. See Network Credentials.
□ LAN/client network IP addresses (and, optionally, the default gateway) have been configured on the FS8600 using the command-line interface.
□ Required ports are allowed on the network. See the FluidFS v6 Support Matrix for specific port information.
□ The FluidFS cluster is connected to the SAN, client network, and internal network. See Install and Connect the FS8600 Hardware.
  • NOTE: To configure a FluidFS cluster with an SCv2080 storage system, a volume must exist on the storage system.
□ Verify that the iSCSI MTU is set to 9000.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\