Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge T320 Systems Owner's Manual

PDF

Installing The VGA Module—Rack Mode

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Align the VGA module with the securing tabs on the control-panel board.
  2. Install the VGA module by pressing down the VGA module until it is fully seated in the securing tabs.
  3. Connect the VGA cable to the control-panel assembly.
  4. Install the control panel for rack mode in the control-panel assembly.
  5. Install the control-panel assembly.
  6. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
  7. If applicable, install the front bezel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\