Dell PowerEdge T320 Systems Owner's Manual

Installing The Wheel Assembly

If applicable, rotate the system feet inward.
Lay the system on its side on a sturdy, stable surface with the base of the system extending off the edge of the surface.
If applicable, remove the system feet.
Align the two retention hooks on the back wheel assembly unit with the two slots on the base of the chassis, and insert the hooks into the slots.
Offset the back wheel assembly slightly to the back of the system and secure the unit in place using a single screw.
Align the two retention hooks on the front wheel assembly with the two slots on the base of the chassis, and insert the hooks into the slots.
Offset the front wheel assembly slightly to the front and secure the unit in place using a screw.
Using two screws, install the support unit on the base of the chassis.
Place the system upright on a sturdy, stable surface.