Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FC830 Owner's Manual

PDF

Installing an expander card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the #1 and #2 Phillips screwdrivers ready.

  4. Remove the expander card.
    NOTE: You must remove the expander card to replace a faulty expander card.

Steps

  1. Align the slots on the expander card with the standoffs on the chassis.
    CAUTION: To prevent damage to the expander card, hold the card only by its edges.
  2. Lower the expander card in to the chassis until the slots on the expander card engage with the standoffs on the chassis.
  3. Tighten the screw to secure the expander card to the chassis.
  4. Align the expander-card cable connector with the connector on the system board (J_PERC).
  5. Tighten the retention screws on the expander-card cable connector until the connector is seated firmly.
    Figure 1. Installing an expander card
    This image shows installing an expander card
    1. screw
    2. expander-card cable connector
    3. expander-card cable
    4. standoff (3)
    5. expander cardNext

Next steps

  1. Install the following:

    1. hard drives or SSDs

    2. hard-drive backplane or SSD backplane

    3. hard-drive cage or SSD cage

  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\