Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FC830 Owner's Manual

PDF

Installing the cooling shroud retention bar

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the #1 and #2 Phillips screwdrivers ready.

  4. Remove the cooling shroud retention bar.
    NOTE: You must remove the cooling shroud retention bar to replace a faulty retention bar or service other components inside the system.

  5. Ensure that the memory module socket ejectors are in the locked position.

Steps

  1. Lower the cooling shroud retention bar into the system until the screw holes on the cooling shroud retention bar align with the screw holes on the chassis.
  2. Install the screws to secure the cooling shroud retention bar to the system.
    Figure 1. Installing the cooling shroud retention bar
    1. screw (9)
    2. cooling shroud retention bar
    3. standoff (2)

Next steps

  1. Install the cooling shroud.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\