MD3060e Enclosure
Management Module Features And Indicators
Figure 1. MD3060e Enclosure
Management Module Features and Indicators
Item
Indicator, Button, or Connector
Icon
Description
1
SAS IN port 0
For SAS connection of the storage enclosure to a server, RAID
controller, or another storage enclosure.
2
SAS IN port 1
For SAS connection of the storage enclosure to a server, RAID
controller, or another storage enclosure.
3
Serial debug port
Dell support only.
4
Telnet port
Dell support only.
5
SAS OUT port
For connection to additional storage enclosures.
6
Diagnostic LED
The numeric display consists of two seven-segment LEDs that
provide information about enclosure identification and diagnostics.
7
Module power indicator
The module power indicator lights green when module power is
on.
8
Service action required indicator (system)
The Service action required indicator
lights amber when there is a fault in one of the components in the
system.
9
Service action allowed indicator
CAUTION: Remove
the expansion module from the system only if the Service action allowed
indicator lights blue. Removing the expansion module from the system
when the Service action allowed indicator is off may damage the system.
NOTE: The Service action allowed indicator LED is not used in server attached
configurations.
Blue
Indicates that you can safely remove the expansion module from
the system.
Off
Indicates that you cannot remove the expansion module from the
system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\