Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Showing the Running-Configuration for an Interface

To view the configuration for any interface, use the following command.

Show the currently running configuration for the specified interface. EXEC mode show running-config interface type { slot/port} Enter the keyword interface then the type of interface and slot/port information:
  • For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet then the slot/ port information.
  • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet then the slot/ port information.
  • For the Management interface on the RPM, enter the keyword ManagementEthernet then the slot/port information.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

Example of the show running-config interface Command 

Dell#show run int gi 2/2
                                 !
                                 interface GigabitEthernet 2/2
                                 no ip address
                                 ipv6 address 3:4:5:6::8/24
                                 shutdown
                                 Dell#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\