Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge T630 Owner's Manual

PDF

Installing the power interposer board

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Follow the safety guidelines listed in the safety instructions section.

Steps

  1. Install the power distribution board (PDB).
  2. Align the power interposer board (PIB) connector with the connector on the PDB.
  3. Align the grooves on the PIB aligned with the pins on the chassis, and then connect the PIB to the connector on the PDB.

Next steps

  1. Install the system board. For more information, see the Installing system board section.
  2. Connect the power cables to the system board and the hard-drive backplane.
  3. If applicable, install the cooling fan assembly.
  4. Install the cooling shroud.
  5. Install the PCIe card holders.
  6. Install the power supply module(s) in their original locations.
  7. Follow the procedure listed in the After working inside your system section.
Figure 1. Installing the power interposer board
This figure shows installing the power interposer board.
  1. power interposer board
  2. power distribution board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\