Monitor mount for 2017 P-series Dell monitors Installation guide

Use the following instructions to attach the client to the P-series mount.

1. Preparing the client —Use a Phillips-head screwdriver to remove the four filler screws from the side of the client.
2. Attaching the client —Install the thin client on the P-series mount with the M4.07-6 screws included in the tool kit.
   • NOTE: The power button should face outwards and air vents should be on top end for proper heat dissipation.
3. Attaching the power adapter holder—Slide the small hooks downward into the vertical slotted holes and the large hooks onto the top edge of the mount. Use the M2.5x0.45 screw to secure the power adapter holder onto the mount as indicated in the following illustration.

   

4. Removing the monitor stand
   1. Place the monitor panel face down on a soft cloth or cushion.
   2. Remove the stand from the monitor by pushing the monitor’s quick release button as indicated in the following illustration.
   
5. Attaching P-series mount to the monitor
   • Remove the monitor screws from the back of the monitor, and use them when you proceed with installation later.
   • Position the P-series mount on the back of the monitor. Tilt and slide the top tabs into the dedicated tab slots, and then firmly slide down bottom edge of mount until it snaps in place.
   
   • Reinstall the monitor screws.
   
   • CAUTION: Do not over-tighten the screws.
6. Reinstalling the monitor stand—Insert the upper stand tabs into the dedicated space on the P-series mount and gently press down until the quick release button snaps into place. Place the monitor in the upright position.
7. Adjusting and securing monitor height (optional)
   • For portrait orientation-Raise the monitor to the maximum height and attach the stopper. Ensure that the arrow on the stopper is facing up and facing front side of the stand. Wrap the stopper around the stand and snap the ends.
   • For landscape orientation-Adjust the monitor height and attach stopper. Ensure that the arrow on the stopper is facing up and facing front side of the stand, and then snap the stopper ends.
   
   • NOTE:

     The stopper is required for P-series monitors to hold the monitor in place at the desired height.

8. Connecting cables —To complete the setup, make all the desired connections, and then plug in the power adapter to an electrical outlet.