- Notes, cautions, and warnings
- Introduction
- Requirements
- Registry Settings
- Install Using the Master Installer
- Uninstall the Master Installer
- Install Using the Child Installers
- Uninstall Using the Child Installers
- Data Security Uninstaller
- Commonly Used Scenarios
- Provision a Tenant
- Configure Advanced Threat Prevention Agent Auto Update
- Pre-Installation Configuration for SED UEFI, and BitLocker Manager
- Designate the Dell Server through Registry
- Extract Child Installers
- Configure Key Server
- Use the Administrative Download Utility (CMGAd)
- Configure Encryption on a Server Operating System
- Configure Deferred Activation
- Troubleshooting
- Glossary
Dell Endpoint Security Suite Enterprise Advanced Installation Guide v3.8
Uninstall Web Protection and Firewall
Command Line Uninstallation
If Web Protection and Firewall are not installed, proceed to Uninstall Encryption Client.
- Once extracted from the Endpoint Security Suite Enterprise master installer, the Web Protection and Firewall client installer can be located at C:\extracted\Threat Protection\ThreatProtection\WinXXR\DellThreatProtection.msi.
-
Go to Add/Remove Programs in the Control Panel and uninstall the following components in this order.
- McAfee Endpoint Security Firewall
- McAfee Endpoint Security Web Control
- McAfee Agent
- Then:
-
The following example uninstalls Web Protection and Firewall .
MSIEXEC.EXE /x "DellThreatProtection.msi"
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\