- Notes, cautions, and warnings
- About your Dell PowerEdge FX2/FX2s
- Initial system configuration
- PowerEdge FX2/FX2s mapping configurations
- Installing and removing PowerEdge FX2/FX2s enclosure components
- Customer and field replaceable units—PowerEdge FX2/FX2s
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Sleds
- Inside the system
- CMC module
- I/O module
- PCIe module
- Expansion cards
- Power supply units
- Cooling fans
- Cooling-fan cage
- PCIe switch board
- Fan interface board
- Interposer module
- Midplane assembly
- Control panel
- KVM panel
- Troubleshooting your system
- Technical specifications—PowerEdge FX2/FX2s
- Getting help
Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual
Cooling fans
Your system
supports eight hot-swappable cooling fans that provide cooling to
the I/O components in the system.
To provide increased cooling to the PCIe components in the system, you can change the Fan Offset options from the CMC web interface.
For more information on the Fan Offset properties, see Advanced Fan Configuration in the CMC Online Help.NOTE: If you are removing
a fan, replace it immediately with another fan. Operating the system
for an extended period of time without a fan installed can cause the
enclosure to overheat.
NOTE: In the event of a problem
with a particular fan, the fan number is referenced by the system’s
management software, allowing you to easily identify and replace the
appropriate fan by noting the fan numbers on the cooling-fan bay.
If any of the fans fail, the LEDs on the fan light up.
NOTE: The
cooling fans in your system are shipped in two sizes of 80 mm and
60 mm width.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\