Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge VRTX Enclosure Owner's Manual

PDF

Removing a low profile expansion card

About this task

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: The system must be closed to initiate expansion card discovery in the CMC.

Steps

  1. Turn off the server module to which the expansion card is assigned, using the operating system commands or the CMC.
  2. Open the system.
  3. Disconnect any cables connected to the expansion card.
  4. Press the release tab of the expansion card latch to lift the latch out of the chassis slot.
  5. Grasp the expansion card by its edges, and remove it from the expansion card connector.
  6. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the expansion card latch.
    NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. The filler bracket is necessary to maintain proper thermal conditions.
  7. Close the system.
  8. Turn on the server module using the operating system commands or the CMC.
    Figure 1. Removing and installing a low profile expansion card
    The figure shows removing and installing a low profile expansion card.
    1. expansion card connector
    2. expansion card latch
    3. metal standoff
    4. expansion card latch release tab
    5. expansion card divider unit
    6. low profile expansion card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\