- Notes, Cautions, and Warnings
- System specifications
- Processor specifications
- System specifications
- Memory specifications
- Video specifications
- Audio specifications
- Port and connector specifications
- Communication specifications
- Camera specifications
- Display specifications
- AC adapter specifications
- Battery specifications
- Physical specifications
- Active pen specifications
- Wireless charging mat specifications
- Environmental specifications
- Using your tablet
- Removing and Installing components
- Technology and components
- System setup
- Entering BIOS without keyboard
- Accessing System Setup BIOS
- Accessing ePSA
- System setup
options
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel software guard extensions screen options
- Performance screen options
- Power management screen options
- POST behavior screen options
- Manageability
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System logs screen options
- Updating the BIOS
- System and setup password
- Troubleshooting
- Contacting Dell
Latitude 7285 2-in-1 Owner's Manual
Installing the docking board
- Insert the docking board into the slot on the tablet.
- Place the docking board bracket on the docking board.
- Replace the M1.6x4 (2) screws to secure the docking board to the tablet.
- Connect the docking board cable to the connector on the system board.
- Install the:
- Follow the procedure in After working inside your tablet.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\