- Notes, Cautions, and Warnings
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade
Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- Hard Drives/SSDs
- Hard Drive/SSD Backplane
- I/O Module Mezzanine Cards
- Network Daughter Card/LOM Riser Card
- Management Riser Card
- SD vFlash Card
- Processor/DIMM Blank
- Processors
- System Board
- System Memory
- NVRAM Backup Battery
- Storage Controller Card/PCIe Extender Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Dell PowerEdge M820 Systems Owner's Manual
Installing A Processor/DIMM Blank
- Remove the blade from the enclosure.
- Open the blade.
- If installed, remove the processor and heat sink.
- Position the processor/DIMM blank on the system board with the holes on the tabs of the processor/DIMM blank secured to the heat sink retention screws on the system board.
- Install the cooling shroud.
- Close the blade.
- Install the blade in the enclosure.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\