- Notes, Cautions, and Warnings
- About Your System
- Using The System Setup And Boot Manager
- Installing Blade
Components
- Recommended Tools
- Removing And Installing A Blade
- Opening And Closing The Blade
- Inside The Blade
- Cooling Shroud
- Hard Drives/SSDs
- Hard Drive/SSD Backplane
- I/O Module Mezzanine Cards
- Network Daughter Card/LOM Riser Card
- Management Riser Card
- SD vFlash Card
- Processor/DIMM Blank
- Processors
- System Board
- System Memory
- NVRAM Backup Battery
- Storage Controller Card/PCIe Extender Card
- Troubleshooting Your System
- Using System Diagnostics
- Jumpers And Connectors
- Technical Specifications
- System Messages
- Getting Help
Dell PowerEdge M820 Systems Owner's Manual
Installing The Network Daughter Card/LOM Riser Card
- CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
- Remove the blade from the enclosure.
- Open the blade.
-
Install the Network Daughter Card/LOM riser card:
- Align the slots on the card edge with the projection tabs on the plastic bracket covering the mezzanine card slots.
- Lower the card into place until the card connector fits into the corresponding connector on the system board.
- Secure the card with the two screws.
- Close the blade.
- Install the blade in the enclosure.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\