Omitir para ir al contenido principal
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.

Dell PowerEdge FC430 Owner's Manual

Removing an SSD carrier

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Turn off the sled and wait until the SSD indicator LEDs on the carrier are off, and then remove the SSD.

    NOTE: When all indicators are off, the drive is ready for removal.
NOTE: All operating systems do not support hot-swappable drive installation. See the documentation supplied with your operating system.

Steps

  1. Press the release button to open the SSD carrier handle.
  2. Slide the SSD carrier out until it is free of the SSD slot.
    Figure 1. Removing an SSD carrier
    This figure shows removing an SSD carrier.
    1. release button
    2. SSD in the carrier
    3. SSD carrier handle

Next steps

  1. If you are removing an SSD permanently, install the SSD blank. If you are installing a new SSD, see the Installing an SSD section.

  2. Follow the procedure listed in the After working inside your system section.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"