- Notes, Cautions, and Warnings
- Introduction
- Preinstallation Setup
- Installing The iDRAC Service Module On Microsoft Windows Operating Systems
- Installing iDRAC Service Module On Supported Linux Operating System
- Installing The iDRAC Service Module on VMware ESXi
- Installing The iDRAC Service Module On Citrix XenServer
- Configuring The iDRAC Service Module
- Frequently Asked Questions
- Linux Installer Packages
iDRAC Service Module 1.0 Installation Guide
Configuring The iDRAC Service Module from RACADM
The iDRAC Service Module can be accessed and configured through RACADM CLI commands. To know the status of the features provided by the iDRAC Service Module, use racadm get idrac.servicemodule command. This command lists the features and their status of the iDRAC Service Module:
- LCLReplication
- OSInfo
- Watchdog
To set or configure the features, use racadm set idrac.servicemodule. <feature name> <enabled or disabled> .
To use the iDRAC Service Module from RACADM, see the objects in the Service Module group in the RACADM Command Line Reference Guide for iDRAC7 and CMC available at dell.com/esmmanuals.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"