- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the memory module
- Replacing the memory module
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the wireless card
- Replacing the wireless card
- Removing the keyboard daughter-board
- Replacing the keyboard daughter-board
- Removing the status-light board
- Replacing the status-light board
- Removing the touch pad
- Replacing the touch pad
- Removing the speakers
- Replacing the speakers
- Removing the fan
- Replacing the fan
- Removing the heat sink
- Replacing the heat sink
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the power and volume-buttons board
- Replacing the power and volume-buttons board
- Removing the I/O board
- Replacing the I/O board
- Removing the system board
- Replacing the system board
- Removing the display assembly
- Replacing the display assembly
- Removing the keyboard
- Replacing the keyboard
- Removing the palm rest
- Replacing the palm rest
- Removing the display panel
- Replacing the display panel
- Removing the display cable
- Replacing the display cable
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- Removing the camera
- Replacing the camera
- Removing the sensor board
- Replacing the sensor board
- Flashing the BIOS
- Technology and components
- System diagnostic lights
- Getting help and contacting Dell
Inspiron 15 70002-in-1 Service Manual
Procedure
- Place the status-light board into the slot on the palm-rest assembly.
- Adhere the foam that secures the status-light board to the palm-rest assembly.
- Slide the status-light board cable into the connector on the keyboard daughter-board and close the latch to secure the cable.
- Adhere the foam that secures the status-light board to the palm-rest assembly.
- Adhere the status-light board cable to the palm-rest assembly.
- Route the speaker cable through the routing guides on the palm-rest assembly and adhere the tape that secures the speaker cable to the palm-rest assembly.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"