Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge T320 Systems Owner's Manual

PDF

Installing An Expansion Card

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Unpack the expansion card and prepare it for installation. For instructions, see the documentation accompanying the card.
  2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  3. If applicable, rotate the system feet inward and lay the system on its side on a flat, stable surface.
    • NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
  4. Open the system.
  5. If applicable, remove the PCIe card holder.
  6. From inside the system, press and push out the expansion card release latch to open it.
  7. If you are installing a new expansion card, remove the filler bracket.
    • NOTE: Keep the filler bracket in case you need to remove the expansion card. Filler brackets must be installed over empty expansion-card slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
  8. Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion card connector.
  9. Insert the card-edge connector into the expansion card connector until the card is fully seated.
  10. From outside the system, rotate the expansion card latch toward the system until it snaps into place.
  11. If applicable, connect the two SAS cables to the expansion card.
  12. If applicable, connect the P3 power cable to the system board.
  13. If applicable, install the PCIe card holder.
  14. Close the system.
  15. If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
  16. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"