Dell PowerEdge T320 Systems Owner's Manual

Removing The LCD Module

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

If installed, remove the front bezel.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
Open the system.
Remove the control-panel assembly.
Remove the control panel from the control-panel assembly.
Remove the LCD ZIF cable from the LCD module ZIF connector on the control-panel board.
- NOTE: The LCD module connector is a ZIF (zero insertion force) connector. Ensure that the locking tab on the connector is released before removal and insertion. The locking tab must be engaged after insertion.
Remove the screw connecting the LCD module to the control-panel assembly and slide out the LCD module.
Figure 1. Removing and Installing the LCD Module
1. LCD module
2. screw
3. LCD module ZIF connector
4. LCD ZIF cable