- Notes, cautions, and warnings
- Introduction
- Data Migration
- Migrate and erase data from old PC
- Check the network settings
- Change the system locale
- Device discovery and prechecks
- Unsupported Windows version
- Applications to close before migrating
- Start Migrate
- Launch Data Assistant on your old PC
- Launch Migrate through SupportAssist on your new Dell PC
- Code verification
- Migrate multiple accounts
- Searching for files and settings
- Troubleshooting network disconnect issues during migration
- Create Data Assistant shortcut
- Select files to migrate
- Migration of file attributes
- Mapping the drives
- Migration progress
- Migration summary
- Migration completion
- Interpret migration report
- Retry or finish the migration process after it was canceled
- Troubleshooting migration failure
- Troubleshooting when migration is completed with warnings
- Issues while launching Data Assistant on old PC
- Program Compatibility Assistant
- Data Erase
- Perform erase without migration
- Prechecks for erase
- Disabling BitLocker
- Troubleshooting hard disk failure issues
- Troubleshooting when external storage is found
- Set reminder
- Levels of erase
- Reset SupportAssist OS Recovery
- Windows reset Windows 10
- Prerequisites for resetting Windows 8.1
- Erase Windows 7
- Troubleshooting Windows reset
- Manual Reboot
- Running Dell Migrate on desktop PCs
- Update .NET Framework
- Tips for faster data migration
- Migration of OneDrive files
- Default exclusions from migration
- Error codes
Dell Migrate User's Guide
Change the system locale
You can change your system locale if your locale setting is not set correctly for the supported regions.
About this task
NOTE: You must select the same locale on both the old and new PCs.
See
Table 1 for the list of supported locales.
When Dell Data Assistant is launched on the old PC, it runs a series of prechecks to validate that the PC has the required prerequisites for Migrate. One of the prechecks is the locale settings.
If the PCs are not on the supported locale, Migrate prompts you to change to a supported locale and try again.
Steps
- In the search box next to the start icon on the taskbar, enter
control. Click
Control Panel from the list of results.
Figure 2. Search for Control Panel using Run 
- In
Control Panel, click
.
Figure 3. Region 
- Select a new system locale from the supported list of locales, and click
OK.
Figure 4. Region Settings 
- Click Restart Now to restart your PC for the changes to take place.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"