- Notes, Cautions, and Warnings
- Copyright
- Introduction
- Preinstallation Setup
- Installing Managed
System Software On Supported Linux And VMware ESX
- Software License Agreement
- RPM For Individual Components
- OpenIPMI Device Driver
- Installing Managed System Software
- Uninstalling Managed System Software
- Installing Systems
Management Software On VMware ESXi
- Using The vSphere CLI
- Using The VMware vSphere Management Assistant (vMA)
- Using The VMware Update Manager (VUM)
- Using The Power CLI
- Accessing Server Administrator on VMware ESXi
- Enabling Server Administrator Services On The Managed System
- Configuring The SNMP Agent On Systems Running VMware ESXi
- Troubleshooting
- Frequently Asked Questions
- Linux Installer Packages
Server Administrator Version 7.4 Installation Guide
Preinstallation Setup
Ensure that you perform the following before installing Server Administrator:
- Read the installation instructions for the operating system.
- Read the Installation Requirements to ensure that the system meets or exceeds the minimum requirements.
- Read the applicable readme files and the Systems Software Support Matrix .
- Close all applications running on the system before installing
the Server Administrator applications.
On systems running the Linux operating system, ensure that all operating system RPM Package Manager (RPM) packages required by the Server Administrator RPMs are installed. If the system had VMware ESX factory-installed, Red Hat Enterprise Linux, or SUSE Linux Enterprise Server, see the Dependent RPMs for Remote Enablement section for information on any RPMs that you need to manually install prior to installing managed system software. Typically, manual installation of RPMs is not required.
Anna arvioinnit (1–5 tähteä).
Anna arvioinnit (1–5 tähteä).
Anna arvioinnit (1–5 tähteä).
Valitse, oliko artikkelista mielestäsi hyötyä vai ei.
Kommenteissa ei voi olla seuraavia erikoismerkkejä: <>()\