Dell Chassis Management Controller Version 1.3 for PowerEdge FX2/FX2s RACADM Command Line Reference Guide

Example for RACADM ?

The following output example shows only part of the actual output for the racadm ? command. Descriptions shown in this example may vary slightly from the descriptions in your racadm session.

racadm ?

help            -- list racadm subcommand description
                                 help <
                                 subcommand> -- display usage summary for a subcommand
                                 ?               -- list racadm subcommand description
                                 ? <
                                 subcommand>  -- display usage summary for a subcommand
                                 arp             -- display the networking arp table
                                 chassisaction   -- execute chassis or switch power-up/down/cycle or
                                 clrraclog       -- clear the CMC log
                                 clrsel          -- clear the System Event Log (SEL)
                                 config          -- modify CMC configuration properties
                                 ...
                                 setniccfg       -- modify network configuration properties
                                 setractime      -- set the time on the CMC
                                 setslotname     -- sets the name of the slot in the chassis
                                 setsysinfo      -- set the chassis name and chassis location
                                 sslcertview     -- display a CA/server certificate in the CMC
                                 sslcsrgen       -- generate a certificate CSR from the CMC
                                 testemail       -- test CMC e-mail notifications
                                 testfeature     -- test CMC feature x
                                 testtrap        -- test CMC SNMP trap notifications
                                 traceroute      -- determine the route of a packet
                                 traceroute6     -- determine the route of a packet
                              

Example for RACADM ? < subcommand>

racadm ? getsysinfo

getsysinfo -- display general CMC and system information
                                 Usage:
                                 racadm getsysinfo [-d] [-c] [-A] [-4] [-6]
                                 -----------------------------------------------------------
                                 Valid Options:
                                 -d : show CMC information
                                 -c : show chassis information
                                 -A : do not show headers or labels
                                 -4 : show CMC IPv4 information
                                 -6 : show CMC IPv6 information