Passer au contenu principal
Quitter

Bienvenue dans l’univers Dell

Mon compte
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Profitez de récompenses et de remises réservées aux membres
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Se connecter Créer un compte Connexion au compte Premier Connexion au programme de partenariat
Nous contacter

Vos paniers Dell.com

Dell PowerEdge T320 Systems Owner's Manual

PDF

Installing The Optical Drive Or Tape Drive

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Unpack and prepare the drive for installation.

    For instructions, see the documentation that accompanied the drive.

    If you are installing a SAS tape drive, you must have an internal SAS expansion card installed. See Installing An Expansion Card.

  2. If installed, remove the front bezel.
  3. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  4. If applicable, rotate the system feet inward and lay the system on it side on a flat and stable surface.
    • NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
  5. Open the system.
  6. If applicable, remove the old drive or the drive blank.
  7. Align the drive with the drive bay.
  8. Slide the drive into the slot until the latch snaps into place.
  9. Connect the power and data cable to the back of the drive.
  10. Connect the power and data cables to the backplane and the system board. The system board connectors are ODD1/TBU and ODD2/TBU. The system can connect up to two optical drives, or one optical drive with one SATA tape backup unit, and one SAS tape backup unit using Dell OpenManage IT Assistant.
    • NOTE: For systems configured with software RAID and installed with PowerVault RD1000 , connect the PowerVault RD1000 data cable to ODD1/TBU (SATA_E) port and the optical drive data cable to ODD2/TBU (SATA_F) port on the system board respectively.
  11. Close the system.
  12. If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
  13. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
  14. If applicable, install the front bezel.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\