Dell OpenManage Server Administrator Version 7.3 Command Line Interface Guide

CLI Command Syntax

Like all Server Administrator commands, the omreport and omconfig command syntax consists of specifying command levels. The first command level is the command name: omreport or omconfig. Subsequent command levels provide a greater degree of specification regarding the type of object on which the command operates or the information that the command displays.

For example, the following omconfig command syntax has three levels:

omconfig storage pdisk

The following table describes these command levels.

Table 1. Example Command Levels
Command level 1	Command level 2	Command level 3	Use
omconfig			Specifies the command
	storage		Indicates the Server Administrator service (in this case, Storage Management) that implements the command
		pdisk	Specifies the type of object on which the command operates

Following the command levels, the omreport and omconfig command syntax may require one or more name=value pairs. The name=value pairs specify exact objects (such as a specific physical disk) or options (such as blink or unblink) that the command implements.

For example, the following omconfig command syntax for blinking a physical disk has three levels and three name=value pairs:

omconfig storage pdisk action=blink controller=id pdisk=<PDISKID>

where PDISKID=<onnector:enclosureID:targetID | connector:targetID>

In this example, the id in controller=idis the controller number such that controller 1 is specified as controller=1.

Bienvenue

Bienvenue dans l’univers Dell

Dell OpenManage Server Administrator Version 7.3 Command Line Interface Guide

CLI Command Syntax

Évaluez ce contenu