- Notes, cautions, and warnings
- Introduction
- OpenManage Integration for VMware vCenter licensing
- Important notes for reference
- Hardware requirements
- Software requirements
- Port information
- Prerequisite checklist
- Installing, configuring, and upgrading OMIVV
- Deploying OMIVV OVF using vSphere web client
- Registering vCenter server by non-administrator user
- Registering OpenManage Integration for VMware vCenter and importing license file
- Upgrading registered vCenter
- Verifying installation
- Migrating from 3.x to 4.0
- Recovering OMIVV after unregistering earlier version of OMIVV
- Appliance configuration for VMware vCenter
- Accessing documents from the Dell EMC support site
- Related Documentation
Zapraszamy
Witryny firmy Dell
Witryny firmy Dell
Witamy w firmie Dell
Moje konto
- Szybkie i łatwe składanie zamówień
- Wyświetlanie zamówień i śledzenie stanu wysyłki
- Tworzenie i dostęp do listy produktów
- Na firmowej stronie administracji możesz zarządzać witrynami, produktami i danymi kontaktowymi firmy Dell EMC.
OpenManage Integration for VMware vCenter Version 4.0 Web Client Installation Guide
Scheduling inventory jobs
About this task
NOTE To ensure that OMIVV continues to display updated information, Dell
recommends that you schedule a periodic inventory job. The inventory
job consumes minimal resources and does not degrade host performance.
NOTE The chassis
gets discovered automatically after the inventory for all hosts is
run. If the chassis is added to a chassis profile, the chassis inventory
automatically runs. In an SSO environment with multiple vCenter servers,
the chassis inventory runs automatically with every vCenter when the
inventory for any vCenter is run at a scheduled time.
NOTE The settings in this
page are reset to default each time the configuration wizard is invoked.
If you have previously configured a schedule for inventory, ensure
that you replicate the previous schedule in this page before completing
the wizard functions so that the previous schedule is not overridden
by the default settings.
Steps
- In the Initial Configuration Wizard, from the Inventory Schedule dialog box, select Enable Inventory Data Retrieval, if it is not enabled. By default, Enable Inventory Data Retrieval is enabled.
- Under Inventory Data Retrieval Schedule, perform
the following steps:
- Select the check box next to each day of the week that you want to
run the inventory.
By default, all the days are selected.
- In Data Retrieval Time, enter the time in
HH:MM format.
The time you enter is your local time. Therefore, if you want to run the inventory at the virtual appliance time zone, calculate the time difference between your local and virtual appliance time zone, and then enter the time appropriately.
- To apply the changes and continue, click Next.
Once you click next, all details that you provide in this wizard is saved and you cannot modify the details from this wizard. You can modify inventory schedule details of the hosts from the tab after completing the configuration from the configuration wizard. See Modifying inventory job schedules in the OpenManage Integration for VMware vCenter User’s Guide at Dell.com/support/manuals. - Select the check box next to each day of the week that you want to
run the inventory.
Podaj ocenę (od 1 do 5 gwiazdek).
Podaj ocenę (od 1 do 5 gwiazdek).
Podaj ocenę (od 1 do 5 gwiazdek).
Określ, czy artykuł były przydatny, czy nie.
Komentarze nie mogą zawierać znaków specjalnych: <>()\