Dell PowerEdge T330 Owner's Manual

Removing a cabled power supply unit

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Follow the safety guidelines listed in the Safety instructions section.
Follow the procedure listed in the Before working inside your system section.

Steps

Disconnect all the power cables from the power supply unit (PSU) to the system board, hard drive backplane, hard drives, and optical drives.
Remove the screw securing the PSU to the chassis and slide the PSU out of the PSU cage.
Figure 1. Removing a cabled AC PSU
1. screw
2. PSU cage
3. non-redundant PSU
4. standoff on the chassis
5. P2 power cable connector
6. P1 signal cable connector
7. P1 power cable connector
8. P4/backplane connector

Next steps

Install a cabled PSU.
Follow the procedure listed in the After working inside your system section.

Vitajte

Vitajte v spoločnosti Dell!

Dell PowerEdge T330 Owner's Manual

Removing a cabled power supply unit

Prerequisites

Steps

Next steps

Ohodnotiť tento obsah