Ana içeriğe atla
Oturumu Kapat

Dell'e Hoş Geldiniz

Hesabım
  • Hızla ve kolayca sipariş verin
  • Siparişleri görüntüleyin ve kargonuzun durumunu izleyin
  • Ürünlerinizin listesini oluşturun ve listeye erişin
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Oturum Aç Hesap oluşturun Premier Oturum Açma İş Ortağı Programı Oturum Açma
Bize Ulaşın

iDRAC 8/7 v2.30.30.30 User’s Guide

PDF

Enabling supported protocol using RACADM

To enable the SSH or Telnet, run the command:
  • Telnet:
    • Using config command: racadm config -g cfgSerial -o cfgSerialTelnetEnable 1
    • Using set command: racadm set iDRAC.Telnet.Enable 1
  • SSH:
    • Using config command: racadm config -g cfgSerial -o cfgSerialSshEnable 1
    • Using set command: racadm set iDRAC.SSH.Enable 1
    To change the SSH port:
    • Using config command: racadm config -g cfgRacTuning -o cfgRacTuneSshPort <port number>
    • Using set command: racadm set iDRAC.SSH.Port <port number>
You can use tools such as:
  • IPMItool for using IPMI protocol
  • Putty/OpenSSH for using SSH or Telnet protocol

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\