Configuring
Your System To Send SNMP Traps To A Management Station
Server Administrator
generates SNMP traps in response to changes in the status of sensors
and other monitored parameters. You must configure one or more trap
destinations on the system running Server Administrator for SNMP traps
to be sent to a management station.
Open the Computer Management window.
Expand the Computer Management icon
in the window, if necessary.
Expand the Services and Applications icon and click Services.
Scroll down the list of services until you find SNMP Service, right-click SNMP Service , and then click Properties.
The SNMP Service Properties window
appears.
Click the Traps tab to add a community
for traps or to add a trap destination for a trap community.
To add a community for traps, type the community name
in the Community Name box and click Add to list, which
is located next to the Community Name box.
To add a trap destination for a trap community, select
the community name from the Community Name drop-down box and
click Add under the Trap Destinations box.
The SNMP Service Configuration window appears.
In the Host name, IP or IPX address box, type the trap destination, Add.
The SNMP Service Properties window appears.
Click OK to save the changes.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\