□ |
1GbE or 10GbE switches can be reached from the
rack.
To ensure high availability to the client network,
Dell recommends using a switch stack or Director class switches. Distributing
the client network ports across discrete switches/blades in the stack
creates a redundant connection to the core network, allowing file
access to continue after a single switch failure.
|
□ |
Ethernet switch infrastructure has ports available
for each FS8600 appliance.
- Fibre Channel with 1GbE appliance – Eight RJ45 ports
for each appliance
- Fibre Channel with 10GbE appliance or 10GbE iSCSI
appliance – Four LC optical or SFP+ (twinax) connections for each
appliance
|
□ |
All client ports are in the same broadcast domain
or port-based VLAN.
|
□ |
Switches are configured to use MTU size equal
to or greater than the minimum supported MTU.
- Dell Force10 switches must be configured to use MTU
1554 or greater.
- Dell PowerConnect switches must be configured to use
MTU 1518 or greater.
- If jumbo frames are used on the client network, the
switches and clients must be configured to use MTU 9000.
|
□ |
(Recommended but not required) Flow control is
enabled on the switches.
|