Unsolved
1 Rookie
•
15 Posts
0
1026
December 14th, 2020 19:00
Aurora R10, drives not showing up in CrystalDiskInfo
I got two drives with the system. The 1TB SSD and a 2TB HDD. I noticed that the HDD doesn't show up in CrystalDiskInfo and other HD software. I believe it was setup from factory as AMD RAID (vs AHCI). Is this normal and are they all like this? Should it be changed?
CrystalDiskInfo - RAID vs AHCI - Also HDD shows as SDD in Win10 optimization
Also I just installed a new 970EvoPlus 2TB using a PCIe adaptor and the drive works great. When I went to check drive optimization all the drives show as solid state drives, including the HDD... again, wondering why.
Anyone else noticed this? Would you leave it like this? Everything appears to be working normally otherwise.
Here is a screenshot, D drive is the HDD that appears to be setup on AMD RAID.
DELL-Cares
Moderator
•
27.8K Posts
•
463 Points
0
December 15th, 2020 13:00
We tried reaching you on a private message asking for the Service Tag but did not receive a response. Please feel free to reply to the private message whenever you are available.
cknoettg420
35 Posts
1
December 16th, 2020 03:00
It's normal. CrystalDiskInfo wants to see an AHCI or IDE controller for AMD systems:
Controllers – Crystal Dew World (crystalmark.info)
Some people have recommended HWInfo instead, but you could run into same problem. These utilities often see the RAID drive as one logical drive instead of separate physical drives.