Unsolved
3 Posts
0
1052
May 17th, 2021 18:00
Aurora R10, trouble booting non-Alienware SSD
I got an Alienware R10 3080, Ryzen 5 5600x, 16gb, and 1tb is what I got. I've got my ssd from my old PC that I used to boot from. Tried booting from the SSD would send me back to the bios. Copied everything from the 1tb harddrive onto the SSD and it gives me a msg about connecting ipv4 and ipv6. Im stumped, I dont wanna have to boot from this ssd.
No Events found!
Vanadiel
8 Professor
•
7.1K Posts
•
29.7K Points
0
May 17th, 2021 19:00
Load the optimized defaults when in your bios, save and exit. It will reboot, and it should become greyed out.
Vanadiel
8 Professor
•
7.1K Posts
•
29.7K Points
0
May 17th, 2021 19:00
Can you check your boot priority as per page 104 of this Manual
The UEFI boot manager will point to the original HDD. Since it cannot locate it I will skip that device and go to device #2 or #3, which is IP4 and IP6 selection by default.
You will have to point the first boot device to your new SSD.
HecticHarddrive
3 Posts
0
May 17th, 2021 19:00
Tried what you said and got these results.
I still can not interact with Boot List and Boot Option priorities.
Tried to launch just ssd and got this.
QR code just said "Pre-boot diagnostics test passed no issues." Im a bit stumped
HecticHarddrive
3 Posts
0
May 17th, 2021 19:00
I went to my bios and boot priority is greyed out and I cant interact with it. Same goes with boot list option. I cant do anything with them.
r72019
8 Professor
•
5.3K Posts
1
May 17th, 2021 22:00
Also, #1: make boot manager.
r72019
8 Professor
•
5.3K Posts
0
May 17th, 2021 22:00
Try removing the 1tb hdd from the pc, you might not have wiped the boot partition.
How did you transfer everything to the ssd?
Clone?
Backup and restore from image?
Copy and paste? (This is not a viable method)