Unsolved
This post is more than 5 years old
1 Message
0
4573
September 29th, 2012 03:00
Alienware aurora light problems but fx card works
have a look at this, i'm having some problems:
http://www.youtube.com/watch?v=jeiqZyaa50M&feature=relmfu
No Events found!
DELL-Chris M
Community Manager
•
56.9K Posts
•
232.1K Points
0
September 30th, 2012 08:00
Aurimukasz,
* Open the Alienware Command Center
* Open the AlienFX Editor
* Access the Theme tab in the upper left corner of the AlienFX Editor and click New Theme
* Make any colored LED changes. Also look for shutdown and restart parameters to make sure the Theme is loaded on Windows restart
* Save the Theme
* Close the Alienware Command Center
* Click Start- Turn Off Computer- Restart
* Check to make sure the Them loads and colored LEDs are as you picked. If still no go, use these instructions to remove and reinstall the Alienware Command Center http://dell.to/HcmulI
Tesla1856
10 Wizard
•
17.9K Posts
•
71.3K Points
0
October 16th, 2012 19:00
For desktops, you should probably start here:
http://en.community.dell.com/owners-club/alienware/f/3746/p/19454040/20128296.aspx#20128296
MrVan
2 Posts
0
October 16th, 2012 19:00
Some of these chips need to be flashed, a bunch of us were trying to figure this out. You can buy a programmer to reflash the chip and see if that helps. LDSISHere was a user that finalized the solution for us. I have a repair shop in MA that is doing this if you are not a tech kinda guy.. check out the laptop thread at : en.community.dell.com/.../20203326.aspx. Similar I am sure. the C2 chips get stuck/corrupted and you lose light control.
DELL-Pablo R
158 Posts
0
October 17th, 2012 10:00
You can also try these troubleshooting steps,
Alienware Desktops: AlienFx/Command Center troubleshooting