Dell Vrtx Network Switch R1-2210

Question

Hi All We recently purchased a new Vrtx with 2 M640 Blades. It came with a R1-2210 Switch as well. Hope someone can help. If you take a look at the below picture. How do I go about mapping the unused internal TE1/3, TE1,4 ports to the External TE0/1 port?   I have gone through the GUI in Advanced and can't find anything.   Any assistance will greatly be appreciated. R

DELL-Shine K · Accepted Answer

What Network Daughter Card (NDC) you have on M640 server. If you have dual port card you will be able to use only 2 ports per server. You can check the network card details on iDRAC 'System -> Network Devices' page.

cit-rk · Answer

Hi Shine

Thanks very much for answering. Looks like the NDC only has 2 ports.

Just another question. If we wanted to run a few VM's on different IP ranges we would have purchase an PCI-E network cards and route out that way?

Regards

R

Blades

Was this post helpful?