Unsolved
This post is more than 5 years old
5 Posts
0
2109
July 25th, 2011 10:00
LUN appears in two storage pools after migration
I recently migrated a LUN from an existing storage pool to a newly created storage pool using FASTLun Migrator. After the migration was complete, the properties of the LUN show that it resides in the original storage pool. However, if I look at the properties of the new storage pool, the LUN appears there as well. The LUN is a member of a Mirroview mirror as well.
Has anyone run across this or have an idea how to resolve this?
This is on a CX4-480. Flare 30.000.5.517
No Events found!
etaljic81
1K Posts
0
July 25th, 2011 13:00
In addition to Avi's recommendation the other thing you can try is restarting the management server. No impact to production. To access it go to: http:// /setup
Kumar_A
2 Intern
•
727 Posts
0
July 25th, 2011 13:00
Have you tried closing the current browser window (which will clear the cache) and opening Unisphere again? You can also try looking at the same information through NaviSecCLI -- if you see the name of the new pool as the owner of the LUN, then it is a GUI issue and should be resolved when you close the window and open Unisphere again.
chadbaird
5 Posts
0
July 25th, 2011 13:00
In NAVISECCLI LUN 115 is showing up in both storage pools. I've closed the browser and reconnected to Unisphere. Also tried on another machine just for kicks. Still have the same issue. Other ideas?
etaljic81
1K Posts
0
July 25th, 2011 14:00
This image contains MV/A and MV/S requirements
etaljic81
1K Posts
0
July 25th, 2011 14:00
See attached image. Can you verify and make sure that all of this was done before you performed the LUN Migration
Wale_T
2 Posts
0
June 25th, 2016 11:00
The next solution is to restart Management Server