Unsolved
This post is more than 5 years old
32 Posts
0
512
Need help in setting up a clone
Looking for the steps involved in setting up a clone on a HP-UX server. The storage array is a CX4-960. I have it already setup on a cx700 from a few years ago, I am looking for the steps involved to automate this thru a script.
Jim_A1
59 Posts
0
September 13th, 2010 15:00
DTP, there are some examples in the navicli manual for snap view, which can be found on powerlink.
Navigate to
and look at the top cli manual.
jim
adin2
57 Posts
0
September 15th, 2010 05:00
Hi
If you just want to set up clone.
1.Set up a Clone private LUN of 128 MB (Min).
2.Create a clone group
3.Select the Lun to be cloned
4.Now Select the Target Lun
all source and target should be defined in storage groups.
dont set the sync rate to high this may impact the array perfomance.
when the initial sync is done break the clone and present it to a secondary server using admsnap util.Also it good to flush (admsnap)the primary host i/o before breaking the clone.
The above are the basic steps involved
check this post for ths commands try to use somthing like perl to automate it
https://community.emc.com/message/457108#457108