Unsolved
This post is more than 5 years old
1 Message
0
778
ns-120 lvm error and https problem
Hi all,
I have a problem with lvm on my ns-120:
This screen after login with ssh to celera:
EMC Celerra Control Station Linux Sat Dec 20 20:57:48 EST 2008
*** slot_0 primary control station ***
EMC NAS Service is not running due to one of the following reasons:
1. EMC NAS Service is still starting or there was an error during
service start-up.
Please logout and try logging in after 5 minutes. It can take up to
15 minutes after Control Station boot for EMC NAS Service to start.
If the problem persists after 3 login retries, please reboot the
Control Station and try again. If this message is still displayed,
contact EMC Customer Support.
2. EMC NAS Software upgrade is in progress, which required stopping
the Service temporarily.
Please DO NOT use the administrative interface while EMC NAS Software
upgrade is in progress. EMC NAS Service starts automatically after
the upgrade finishes.
Until EMC NAS Service starts, administrative commands and interfaces
will not operate.
When i run this command: /nas/http/nas_ezadm/etc/script start
[root@KOLIBER etc]# /nas/http/nas_ezadm/etc/script start
mkdir: cannot create directory `/nas/tasks': File exists
chgrp: changing group of `/nas/tasks': No such file or directory
chown: changing ownership of `/nas/tasks': No such file or directory
Starting apl_task_mgr.
Error: /nas/site/nas_eventlog.cfg : could not open
Starting tomcat web server.
Error: /nas/site/nas_eventlog.cfg : could not open
Couldn't read /nas/sys/nas_eventlog.cfg
mkdir: cannot create directory `/nas/tomcat': File exists
chmod: cannot access `/nas/tomcat/logs': No such file or directory
/nas/http/webui/etc/tomcat: line 43: /nas/tomcat/logs/catalina.out: No such file or directory
/nas/http/webui/etc/tomcat: line 44: /nas/tomcat/logs/catalina.out: No such file or directory
/nas/http/webui/etc/tomcat: line 45: /nas/tomcat/logs/catalina.out: No such file or directory
/nas/http/webui/etc/tomcat: line 55: /nas/tomcat/logs/catalina.out: No such file or directory
I see these three in inactive state whe i use lvscan command:
[root@KOLIBER sbin]# lvscan
ACTIVE '/dev/emc_vg_pri_ide/emc_lv_home' [600.00 MB] inherit
ACTIVE '/dev/emc_vg_pri_ide/emc_lv_nas_jserver' [1.38 GB] inherit
ACTIVE '/dev/emc_vg_pri_ide/emc_lv_celerra_backup' [840.00 MB] inherit
ACTIVE '/dev/emc_vg_pri_ide/emc_lv_celerra_backendmonitor' [8.00 MB] inherit
ACTIVE '/dev/emc_vg_pri_ide/emc_lv_celerra_audit' [120.00 MB] inherit
ACTIVE '/dev/emc_vg_pri_ide/emc_lv_celerra_commoncache' [512.00 MB] inherit
ACTIVE '/dev/emc_vg_pri_ide/emc_lv_celerra_ccc' [560.00 MB] inherit
ACTIVE '/dev/emc_vg_pri_ide/emc_lv_celerra_wbem' [1.00 GB] inherit
INACTIVE '/dev/emc_vg_lun_0/emc_lv_nas_var_dump' [1.65 GB] inherit
INACTIVE '/dev/emc_vg_lun_0/emc_lv_nbsnas_jserver' [1.38 GB] inherit
INACTIVE '/dev/emc_vg_lun_0/emc_lv_nas_var_auditing' [120.00 MB] inherit
I can succesuly activeted and mount it, but after restart the CS, they are still in inactive state.
This i what i have after run command "getreason"
[root@KOLIBER sbin]# ./getreason
10 - slot_0 primary control station
4 - slot_2 configured
Please help me.
Best Regards/ Lukasz
christopher_ime
2K Posts
0
July 6th, 2013 11:00
Lukasz,
Please consider moving this question to the proper forum for maximum visibility. Questions written to the users' own "Discussions" space don't get the same amount of attention and questions can go unanswered for a long time. You can do so by selecting "Move" under ACTIONS along the right. Then search for and select: "Celerra Support Forum" which would be the most relevant for this question.
This would require deeper analysis than can be performed via the forums. If you haven't already, please open up a support ticket for engineering to review.