Unsolved
This post is more than 5 years old
1 Rookie
•
88 Posts
0
2036
Server appears not in server list under Non-Compliant
Last week I updated my OME to 2.3 and all things seemed fine.
Yesterday I added a server (M620, 2016 Standard with GUI) after a reinstall as new to OME. The server must appear under Non-Compliant because I know that the firmware of the HDs is out of date.
But the server appears whether under Compliant nor under Non-Compliant.
Today I repeated the process. I deleted the server from OME, removed and reinstalled OMSA 8.5 on the server and added it again to OME. I could see how the amount of non compliant servers switched from 68 to 69. The amount of servers in whole is now correct (85). But the server appears not under Non-Compliant.
Of course I refreshed the view, but no change.
I know this issue from an earlier version of OME. The work around for this was switching from "Downgrade disabled" to "Downgrade enabled", wait until the view had refreshed and then switch back to "Downgrade disabled". But this work around did not help now.
Any suggestions?
Barbara
bennyboy84
1 Message
0
September 20th, 2017 16:00
Having the same issue
Openmanage 2.3.0.1721
Fresh install of Openmanage on Win2016 VM hosted on a Win2012r2
3 servers added so far for testing
T610 (Win2012r2 OMSA 8.5)
T620 (Win2012 r2 OMSA 8.5 + iDrac)
R320 (Linux iDrac)
Had done a few updates on the T610 and T620
Still have more updates, but now they not showing under Non-Compliant tab (or any tab)
Only the R320 is listed
System Update page showing 3 Non-Compliant in pie chart, but Non-Compliant tab only has 1.
Have removed all 3 servers and re added
Have rebooted a number of times
Checking on the OpenManage server not remotely
Also found the old fix of "Downgrade enabled" and then "Downgrade disabled" did not work
Current catalog was set to Repository Manager v2.2.0 local Openmanage Catalog
When changing to dell ftp server as source
Get 2 servers Non-Compliant tab but still missing 1
If i had setup Repository Manager wrong, changing to dell ftp should fix the issue and show 3 servers, but it only shows 2 in Non-Compliant tab but 3 in the pie chart.
In any case, deleted the repository and local copy, recreated the OpenManage repository and re exported.
Set OpenManage back to the new local repository and same issue, down to 1 server.
DELL-Shivendra K
685 Posts
0
September 24th, 2017 11:00
We tried the scenario mentioned here and could not reproduce the problem. I would request you to get in touch with Dell Support. They can take a closer look at your setup / environment and help resolve the problem.
DELL-Shivendra K
685 Posts
0
October 12th, 2017 09:00
Update:
This problem is seen only with 11G servers. Please get in touch with Dell Support for resolution.